AL-KO hub nut special B for stub axles without split pin
Part No
HUB414
AL-KO hub nut special B for stub axles without split pin. AL-KO part no. 1312008 !!M16 x 1.5 Thread!!
Fitting Instructions:
· To Fit a new collar nut)
· Tighten the collar nut to 50 Nm, at the
same time rotating the hub, until
resistance can be felt (use a torque
wrench)
· Back off the collar nut 30 degrees and
lock using the special tool
. Stake the collar of the nut into the
groove on the stub axle.
End play of 0.05 mm is permitted.
The collar of the nut must not be
sheared.
Overtightening the bearings causes
bearing damage.
· Fit the bearing hub cap
10 available in stock
£2.90 £2.42
AL-KO hub nut special B for stub axles without split pin
| Manufacturer | AL-KO |
|---|
